Wiring Instructions for the Remote Control Unit

1) Mount strips in desired locations.

The Skinny'z come with 2 wires on both ends of the Skinny,  if only using one side of the Skinny'z wire (example -gas tank application)  cut off one end of the wire approximately 1.5 inch from the Skinny strip, and then separate the positive and negative wires. Then, cut the negative wire a little shorter, to make certain the wires are not the same length (so they do not contact each other), then cut a small piece of supplied heat shrink and apply over the shortened wires. Then apply light heat to seal the wire from damage. Make sure that shortened wire is hidden out of the way when finished.

2) Run all positive wires towards battery location & combine together. Strip wires and leave 1/4" of copper strand.

3) Run all negative wires towards battery location & combine together. Strip wires and leave 1/4" of copper strand.

4) Run the copper strands through the small end of the plastic insert and out the larger end. Bend the strands over the insert approximately 1/16th inch (on each side of insert).

5) Plug insert tightly into remote control pod controller.

Make sure that you plug it into the side that says “pods” and make sure that the positive (red) wire is plugged into the control pod with the (+) and the negative wire is plugged  into the control pod with the (-).

6) On the control pod controller that says “12v”, attach a wire to this side, approximately 6" - 12" in length. Strip wires and run into black insert (like step # 4) and push insert tightly into “12v” side of the remote control pod controller.

7) Attach the “negative” wire directly to your 12 volt negative source, then attach the “positive” wire directly to your 12 volt positive source.

8) Your Skinny'z strips should now come on. Hold your remote control button down until the Skinny'z strips flash (3 fast times) and  your system is programmed and ready to use!

Wiring Instructions for the Toggle Switch

1)Mount strips in desired locations.

The Skinny'z come with 2 wires on both ends of the Skinny. If only using one side of the Skinny'z wire (example -gas tank application), cut off one end of the wires approximately 1.5 inch from the Skinny’z strip. Separate the positive and negative wires, and then cut the negative wire a little shorter, to make certain the wires are not the same length (so they do not contact each other). Cut a small piece of supplied heat shrink and apply over the shortened wires, and then apply light heat to seal the wire from damage. Make sure that shortened wire is hidden and out of the way when finished.

2) Run all positive wires towards battery location and combine together. Strip wire leaving 1/16” of copper strand.

3) Run all negative wires towards battery location and combine together. Attach directly to negative side of 12 volt power source.

4)Run all positive wires together and strip ends, then attach into one side of supplied red barrel connector and crimp with wire crimpers.

5) Choose desired location for toggle switch (usually mounts under seat on the left side) and then mount toggle switch.     

6) Attach one end of toggle wire to the red barrel connector from the Skinny’z strips and then attach a supplied red barrel connector to the other wire from the toggle switch.

7) Locate the red fuse holder, then cut the wire loop directly in half. Strip ends and attach one end of the wire to the red barrel connector from the toggle switch. 

8) Attach the other end to the 12 volt positive power source.